Falcon rotator problem

[AdrianF]

Hello,

I seem to be having an issue since the last firmware update.

The falcon rotator will connect in the unity and Nina softwares. During the start of the sequence the rotator behaves as expected. But at the end of the night, when the sequence is ending, I have a command to return to zero position. This commend fails in the sequence and the sequence remains stuck at this step. I then have to go the equipment tab, and initiate the commend form there. Tonight nina reported that the rotator disconnected for no reason in the middle of the sequence.

I look forward to your response. I can provide NINA sequence logs if you believe this would be helpful

All the best
Adrian

[Evans]

New firmware (1.7) fixes a couple of memory leaks. I think this might be the case here.
Please wait for a couple of days and we'll launch the new firmware.