Pegasus Astro Forum

Hi,

Several months back I swapped out an older Focus Cube v2 with a new one. I've noticed with the new Focus cube that it takes half as many steps to reach focus compared to the old one in NINA. So instead of 2 microns per step I'm probably moving closer to 4 microns. Did something change in the firmware in the last couple of years? Or is there a software/ASCOM setting that needs tweaking. This isn't a show stopper but I do want to make sure I've got everything configured correctly.

Thanks,

--Steve

We have switched our firmware from half step to full step drive as the resolution is very high and there is no need to use half step with this specific device.

Thanks. Just wanted to make sure I hadn't misconfigured things.