Pegasus UPB V2 and Focus motor problems
Posted: Sun Mar 14, 2021 6:27 pm
I have the UPV V2, despite doing the update to v 1.4.4 I keep getting asked to perform the update. Even after an uninstall he version of UPB is 1.4.3
Also noticed that although its shown as connected and the software interface shows it as running, the Pegasus Focus motor is not driving at all. Ive changed cables, same problem. When to to GoTo ***** position, the software shows it as connected and the interface is incrementing but nothing is happening at the Motor end.
Running this on Windows 10
Also noticed that although its shown as connected and the software interface shows it as running, the Pegasus Focus motor is not driving at all. Ive changed cables, same problem. When to to GoTo ***** position, the software shows it as connected and the interface is incrementing but nothing is happening at the Motor end.
Running this on Windows 10