Page 1 of 1

Loosing Connectivity to Rotator and possibly Focuser

Posted: Mon Nov 07, 2022 5:07 pm
by sreilly24590
I installed the UPBv2 with the intent to eliminate as many cables running from the NUC to the imaging system. I have been experiencing disconnects to both the Optec Pyxis 3" rotator and the Robo Focus controller. I've checked all USB settings under Device Manager and none have power save settings for any of the ports. My next move is to try different USB port on the Onlogic Helix 610 Intel Comet Lake Industrial Edge Computer With Optional Hot Swap Storage. These random, or appear to be random, disconnects cause fatal errors in ACP disconnecting the mount and shutting down imaging sessions. Trying to find a logical path the eliminate any timing or connection issues this may have. These errors started after installing the Pegasus and replacing the rotator RG 11 to serial cable with a RJ 11 to USB cable. trouble shooting suggestions much welcomed.....