Pegasus Astro Forum

Hello,
I found a odd behavior of Falcon Rotator with Sequence Generator pro. I will try to describe the situation:

1. I have object with rotation angle od 337 deg.
2. When i start the session, Rotator go to position given by SGP - 337 deg
3. Check in SGP reveal that there is a 0,5 deg error and try to move rotator not by 0,5 deg but to absolute position of 337 deg
4. Rotator didn't move because it is at 337 deg
5. SGP after fail tries to repeat step 3.

Did you encounter that problem? Is there a way to move rotator not to absolute posiot but "by desired angle"?

I will be gratefull for any help because now I must manually move rotator by 0,5deg.

Thank you and best wishes
Pawel

Any thoughts?

So, there is no thoughts at all...

pity
Best wishes to all.

I have the same issue, the falcon will not react to small goto commands it seems.

I bypassed the problem by increasing the tolerance for the rotation to +-2°. The it will work always. Less than than can become unreliable.

Cheers,

Stephan