Pegasus Astro Forum

Hi there.

I'm using the latest unity platform and drivers. I've setup my zero position based on my sensor position, save that position with the unity platform. Close and open the app again, still good remembered the position. Restart the computer, open unity, still good, position remembered. Shutdown computer , power off, turn back on, rotator says its at 283 degrees instead of zero... how do I fix that?

With the older "non unity" drivers I don't remember having this problem

Cheers,
Steeve

Hi,
Rotator stores the last position to its eeprom memory after 5 secondsof motor inactivity. It does not have to do with Unity or any software. This has to do with firmware.
We'll try to replicate your issue as this never should happen (to be honest we do not have similar reports)