Falcon not remembering last position after shutdown

Questions and feedback about the rotator itself, adapters, de-rotation etc
Post Reply
bsteeve
Posts: 4
Joined: Wed Dec 08, 2021 3:11 am

Falcon not remembering last position after shutdown

Post by bsteeve »

Hi there.

I'm using the latest unity platform and drivers. I've setup my zero position based on my sensor position, save that position with the unity platform. Close and open the app again, still good remembered the position. Restart the computer, open unity, still good, position remembered. Shutdown computer , power off, turn back on, rotator says its at 283 degrees instead of zero... how do I fix that?

With the older "non unity" drivers I don't remember having this problem

Cheers,
Steeve
User avatar
Evans
Site Admin
Posts: 504
Joined: Wed Dec 02, 2020 3:06 pm
Contact:

Re: Falcon not remembering last position after shutdown

Post by Evans »

Hi,
Rotator stores the last position to its eeprom memory after 5 secondsof motor inactivity. It does not have to do with Unity or any software. This has to do with firmware.
We'll try to replicate your issue as this never should happen (to be honest we do not have similar reports)
Post Reply