Page 1 of 1
FLI CCD with PuPBv2
Posted: Tue Feb 02, 2021 9:54 pm
by Bjoern
Good evening,
I need a power cable to connect a FLI Microline camera. Is there already an appropriately assembled cable for the power box here ?
Many greetings
Björn
Re: FLI CCD with PuPBv2
Posted: Sun Feb 07, 2021 1:09 pm
by Evans
Currently we do not provide an FLI cable.
Pinout seems to be easy but we do not have it yet.
Please check if FLI can provice a 2.1mm to FLI plug converter cable.
Re: FLI CCD with PuPBv2
Posted: Sun Aug 28, 2022 10:29 pm
by BarryS
I’m in the same boat. Did you ever find a solution and does it work without creating noise in the image?
Barry
Re: FLI CCD with PuPBv2
Posted: Tue Aug 30, 2022 8:52 pm
by Evans
This is what you need. a 2.1mm -> Kycon Kppx-4P connector
https://mouser.com/ProductDetail/MEAN-W ... 5rhQ%3D%3D
Re: FLI CCD with PuPBv2
Posted: Tue Aug 30, 2022 8:58 pm
by BarryS
Thanks for your reply. Unfortunately that pinout doesn't line up with the FLI +/- pins. Please see page 19:
https://www.flicamera.com/pdf/MicroLine_RevI.pdf
Here is the pinout for the one you just linked me to:
https://www.meanwell.com/webapp/product ... UG-P1J-R7B
They are not the same.
Are you able to manufacture one for me with the proper pinout?
Regards,
Barry
Re: FLI CCD with PuPBv2
Posted: Wed Aug 31, 2022 2:42 am
by BarryS
I think I have found the correct cable for the FLI. Here is the spec sheet showing the proper pin out.
https://tsi.tyconsystems.com/doc/UserMa ... ni_DIN.pdf
Here is the website to order
https://tsi.tyconsystems.com/doc/UserMa ... ni_DIN.pdf
Also available on Amazon.
I’ll test and report back.