Page 1 of 1

DMFC and win XP

Posted: Tue Apr 26, 2022 5:19 pm
by phenrotay
Hello,
Is it possible to run the dual motor focus controller with windows xp?
As far as I can read ascom 6.6 is required, which does not support xp.
I know that XP is pretty old but still alive in my usual setup.
CS
Pierre

Re: DMFC and win XP

Posted: Mon May 09, 2022 9:24 am
by Evans
The older software works fine with XP
Please use the older standalone software available from our website

Re: DMFC and win XP

Posted: Mon May 16, 2022 4:40 pm
by phenrotay
Then there is a major problem somewhere.

I received myPegasus focus motor and DMFC controller today.
Unfortunately, I cannot run this equipment from my XP computer !
I downloaded the “older” software as was pointed out above :
Focus Controller Setup v.4.4.5 (Sep/21)
and
ASCOM Focus Driver v2.19 (Jan/22)
but they cannot be installed : when I try to run these, each is reported as not being an XP 32 bits application, and the installation fails immediately.
This is NOT a download problem. I was able to install the same files on a Win10 machine for test.
So I am stuck – I do not envisage to change my present capture computer.

Help please...

Pierre