Hello All,
I've got a FocusCube2 connected to a UPB2, and am also using a MiniX Mini PC (W10 PRO, 64 bit, all updates), with remote access through another W10 PC by windows "native" remote.
I had been able to manipulate the FC2 through its standalone software without issue. Today I'm working to set up steps size and I can't get the FC to connect.
The error message I get is "Connection to Controller was lost".
I've reinstalled the software and I've also tried uninstalling/reinstalling the USB drivers based on this post:
viewtopic.php?f=12&t=85
I've had no success based on reinstalling software or drivers.
I can connect to the UPB and FC with their standalone software when I plug directly into my ThinkPad.
My end goal is to use Sequence Generator Pro, but I'd like to get this all working with the Pegasus software first so I have a stable starting place. I would appreciate any suggestions.
Thanks!
Stephanie
FocusCube2 not connecting to UPB2 on MiniX
-
- Posts: 2
- Joined: Tue Aug 24, 2021 4:59 pm
-
- Posts: 2
- Joined: Tue Aug 24, 2021 4:59 pm
Re: FocusCube2 not connecting to UPB2 on MiniX
Hello All,
Inexplicably, today my setup seems to be working just fine.
I don't think it was the overnight reboot, since I'd rebooted while I was having issues. If anyone has had a similar experience I'd love to hear about it. I'm not confident about how reliable the MiniX is and I'd appreciate hearing any feedback
Thanks again!
Stephanie
Inexplicably, today my setup seems to be working just fine.
I don't think it was the overnight reboot, since I'd rebooted while I was having issues. If anyone has had a similar experience I'd love to hear about it. I'm not confident about how reliable the MiniX is and I'd appreciate hearing any feedback
Thanks again!
Stephanie