I have both a PPB Micro and a PPB Advance. When I start up PPB software (Ver 1.16), it connects to the PPBA and functions normally. However, I cannot start and connect to the PPBM. If I try to connect via a 2nd instance, it sees the PPBM and even assigns a COM port, but when trying to connect, it cannot find the COM port!
Any suggestions. Any other info that would be helpful?
TIA!
Bryan
Cannot connect second instance of software
Re: Cannot connect second instance of software
Can you check the port on each instance.
I tried to replicate your issue with no success
Below image shows a Micro and an Advance in parallel
I tried to replicate your issue with no success
Below image shows a Micro and an Advance in parallel
Re: Cannot connect second instance of software
Using USBVIEW, I was able to determine that, even though the Pegasus software decided that COM9 was the appropriate port, the actual connected port was COM13. I changed from 9 to 13 in Device Manager and both instances connect now.
This begs the question, however, of why the Pegasus software identified an incorrect port.
Bryan
This begs the question, however, of why the Pegasus software identified an incorrect port.
Bryan
Re: Cannot connect second instance of software
Probably it was an older COM port stored in windows registry.
Re: Cannot connect second instance of software
Can this be improved in the next version of the Pegasus software? It's not very useful app, to be honest, if it cannot find the correct port on its own.
Bryan
Bryan
Re: Cannot connect second instance of software
It works perfectly fine if you have set it to "Auto"
If you have already selected a port it will try only this specific port.
If you have already selected a port it will try only this specific port.
Re: Cannot connect second instance of software
This is not my experience.
I never set a COM port on the initial install of either the PPBM or the PPBA, which was installed at a later date. If I click Auto Select now, it still fails.
Bryan
I never set a COM port on the initial install of either the PPBM or the PPBA, which was installed at a later date. If I click Auto Select now, it still fails.
Bryan
Re: Cannot connect second instance of software
Probably it has to do with the windows framework. We'll try to replicate your issue and if there is a visible problem we'll fix it in the next release.