Hello all
My name is Menno, I'm from The Netherlands.
Since a few days I have the Pocket Powerbox Micro and it works fine sofar.
But there is something not clear to me in the software.
In the Control tab, I set DSLR Output to OFF and in the Config tab, I did choose under Power On Startup for the 12V x 4 outputs ON option. I clicked Set and a message was there that the setting is saved to the EEPROM.
But it seems that it's not saved on the EEPROM? The next time I power up my PPM, those settings are back to how they were: DSLR Output is ON and Power On Startup is All outputs ON ?
So either the software is not reading the EEPROM or it's not saved to the EEPROM at all?
The settings for the dew channels (Auto and Aggressiveness) are remembered though.
Model: PPB Micro, revB
Firmware: v2.6
Software: 1.17.0.0
Question on saving to EEPROM on PPM
Re: Question on saving to EEPROM on PPM
It seems there is a bug. Noted to be fixed in the new upcoming release.