Is it possible to define point/degree of reverse rotation?
Posted: Fri Jun 24, 2022 10:39 am
Hello,
I have installed the Falcon Rotator in my image train. When operating the rotator I can see in my setup that it turns counter-clockwise until 220° when trying to move from there to e.g. 225° the rotator reverses direction to prevent cable problems and turns clockwise to the desired degrees. So far so good.
Question: Is it somehow possible to define at what point (or at what degrees) the rotator should reverse direction?
I'd like to set it to reverse direction at 190° instead of 220° for cable management reasons (the pack of cables would otherwise block the fan outlets of my cooled camera).
Thank you for any suggestion.
Herwig
I have installed the Falcon Rotator in my image train. When operating the rotator I can see in my setup that it turns counter-clockwise until 220° when trying to move from there to e.g. 225° the rotator reverses direction to prevent cable problems and turns clockwise to the desired degrees. So far so good.
Question: Is it somehow possible to define at what point (or at what degrees) the rotator should reverse direction?
I'd like to set it to reverse direction at 190° instead of 220° for cable management reasons (the pack of cables would otherwise block the fan outlets of my cooled camera).
Thank you for any suggestion.
Herwig