Is it possible to define point/degree of reverse rotation?

[AstroHD]

Hello,
I have installed the Falcon Rotator in my image train. When operating the rotator I can see in my setup that it turns counter-clockwise until 220° when trying to move from there to e.g. 225° the rotator reverses direction to prevent cable problems and turns clockwise to the desired degrees. So far so good.

Question: Is it somehow possible to define at what point (or at what degrees) the rotator should reverse direction?

I'd like to set it to reverse direction at 190° instead of 220° for cable management reasons (the pack of cables would otherwise block the fan outlets of my cooled camera).

Thank you for any suggestion.

Herwig

[Evans]

Hi Herwig,
Unfortunately no, with the current firmware
The 220 deg is the hard limit.
However, we'll check how we can support that in a future firmware release.
Regards,
Evans

[archer1960]

I would like this capability too!

[AstroHD]

Thank you,
will follow the change log of future firmware releases