Try to set OFF the ports and ON again in the "power startup section"

The UPBv2 drives the motor with half step drive for higher resolution.
I am afraid this cannot change with current firmware

Hi Peter, If your intention is to enable the device when you plug the USB, then try to unplug the battery. You can open the lid and remove one battery pole /cable. When the battery is connected you need to press the right button to wake up the device (the device goes to sleep and you cannot wake it ...

What is the firmware of the mount, please? Can you please check that you have 1.19?

We are working on a hand controller. It will be more complicated than NSEW buttons but you will like it.
The estimated launch should be after summertime.

Mount consumes 2-2.5A during slewing and 0.65Amps during tracking. We provide a 5A PSU which, to be honest, is an overkill for what the mount needs
A LiFePo battery is perfect. I use the same type.

The latest Unity fixes the layout issue,
Also allows you to custom-make a new layout and save templates.

It should be ok now. (latest Unity)
We fixed the DPI issue.

You can now configure the layout and custom-make your own layout template.
I believe this was the best choice to have flexibility in dashboard window layout.

I think there is a limit on the ASCOM driver of nearly 1 million steps. I never thought that someone would need more.
Will check how we can increase the limit to 2mil.

Hi,
I am afraid we have no plans to make a smaller device. However, we'll explore the option to have some kind of brackets that will allow the 150 to be attached to smaller diameters.

Please upgrade to the latest Unity. There is a settings tab at Uranus dashboard that allows you to tune /offset each sensor including cloud sensor

Hum, I cannot replicate this issue
DEC and RA keypad works fine with latest Unity Mobile application (IOS and Android).
Please provide more info of your mobile type and version.

Thank you for the recommendation
It is indeed on our future firmware development list.

When the mount is turned off but the USB cable remains inserted into your PC, you will receive this message.
By the time you will switch on the mount, the message will go away as the mount will be again responsive

It is again in full stock so we are offloading any backorders.

It is not required. The v2.8 is for the latest PCB revision batch. If there is a firmware update Unity will prompt you to upgrade.

Unfortunately, UPBv1 is currently not supported in Unity Platform

You just name the port so you can remember what you have plugged in. E.g Esprit100 Heater

The answer to your question is always in the product manual